How to start the sand making machine correctly at low temperature

The cold winter has come, and the temperature is dropping day by day. The diesel and water commonly used in sand making equipment are also more likely to freeze in this season, so it will be more difficult to start the equipment. This requires our users to do a good job in the maintenance of sand making equipment in this season. When the temperature is low in winter, in order to ensure the normal operation of the sand making machine, it is necessary to pay special attention to correct maintenance, especially the lubrication and maintenance of the equipment. Therefore, when choosing lubricating oil, it is also very particular.

Jaw crushers, impact crushers, cone crushers, impact crushers, etc., must be able to work without load below minus 50 degrees Celsius. Because the temperature in winter is relatively low, it will not only greatly reduce the service life of the crusher, but also make the oil and water in the crusher more likely to be frozen, so do a thorough inspection and maintenance of the crusher before winter to ensure the safety of construction machinery Overwinter, so as not to affect the production due to machine problems.

Due to the relatively dry climate in winter, in some fire-prone places, it is required to use a lubricant with good flame resistance (fire-resistant fluid), and flammable mineral oil cannot be used. The adaptability of the lubricant to the seal is required to avoid damage to the seal. In the process of vertical shaft sand making machine-made sand, the machine-made sand equipment should be turned on first, and then the vibrating feeder should be turned on to start feeding evenly and moderately, so as to ensure the quality of the products produced by the equipment and reduce failures and material blocking.

Cleaning the appearance of diesel engines, chassis, and working devices of construction machinery can remove scale and decontamination. During the cleaning process, damage to various devices and components and oil leakage can also be found, so as to do a good job in the preliminary work for the next maintenance. It is strictly forbidden to use high-pressure and high-temperature water guns to wash parts with high waterproof requirements, especially electrical parts, to avoid damage.

Previous: Which grinding mill is more suitable for dolomite ore?

Next: Key points of jaw crusher installation process